Zweistoffduese

Zweistoffdüsen

Zweistoff-Düse

Düsensystem Automatisch oder Manuell nach Kundenwunsch asl Druckdüsensystem Pneumatusche Zerstäüber etc.

Die Al Produktlinie ist wie alle Düsen von Delavan im Baukastensystem aufgebaut.

Die Zweistoff-Zerstäuber Düsen können durch Austausch der Zerstäuber an die Erfordernisse angepasst werden.

Die Al Düsen sind  Shut / Off / Clean Out Düsennadel oder als Clean-Out oder als Shut-Off Nadelsystem erhältlich.

Die Zulaufregelung und Steuerung erfolgt je nach Typ mechanisch manuel bis pneumatisch automatisiert.

 

Zweistoffdüsen Delavan Typ AL

External MiX

Internal Mix

AIRO

GA

GC

VCN

SN

Swirl Air

AL, AL15, AL 30, AL 45, AL 60 AL 75-90

Air atomizing nozzle
1/8 - 1/4", 315 l/min | AL series DELAVAN SPRAY TECHNOLOGIES
The Delavan AL air atomising series spray nozzles offer the user a wide
variety of spray patterns, flow rates and atomisation. Unlike hydraulic or
pressurised nozzles where the energy from the pressure of the liquid is
used to atomise, the AL series of nozzles use the energy of a pressurised
gas (typically air) to atomise the liquid. This allows the liquid to be fed
under lower pressure and still achieve fine atomisation. This is also
advantageous for abrasive or high viscosity liquids.
The nozzles are so designed that flow rates from almost no flow, as in the
siphon-fed, to over four litres per minute can be achieved. (For higher flow
rates in an air atomised spray, refer to Delavan’s Swirl-Air series.)
The low flow rates and air atomisation combine to give the AL series
extremely fine atomisation. Droplet sizes below 50 microns Sauter Mean
Diameter can be expected. In the lower flow rates, droplet sizes below 20
micron SMD are not uncommon. video
zoom
The Delavan AL air atomising series spray nozzles offer the user a wide
variety of spray patterns, flow rates and atomisation. Unlike hydraulic or
pressurised nozzles where the energy from the pressure of the liquid is
used to atomise, the AL series of nozzles use the energy of a pressurised
gas (typically air) to atomise the liquid. This allows the liquid to be fed
under lower pressure and still achieve fine atomisation. This is also
advantageous for abrasive or high viscosity liquids.
The nozzles are so designed that flow rates from almost no flow, as in the
siphon-fed, to over four litres per minute can be achieved. (For higher flow
rates in an air atomised spray, refer to Delavan’s Swirl-Air series.)
The low flow rates and air atomisation combine to give the AL series
extremely fine atomisation. Droplet sizes below 50 microns Sauter Mean
Diameter can be expected. In the lower flow rates, droplet sizes below 20
micron SMD are not uncommon.